Hi everyone,
I'd like to get some expert feedback on lift kits. I just had a Fabtech 3" suspension lift installed on my 01' 4x4 yota
and the 285-75R-16 tires on Azusa 16x8s rubs when I turn the wheels sharp. Is there something I can do that won't break
purse to get another 1-2 inches of lift. I was told a body lift may be the solution?

Thanks,

Torri

Depends ALL where it rubs. Could be the offset of the wheels etc... Not always just about lift. Give us some more info on where it hits

there are a lot of spots to point out. like wheel alignment, wheel offset, lift, and more. Just check anything maybe its not the lift because 3" is totally good.