does anyone have any special tricks to tighten the top 2 tranny bolts? When i took the engine out i removed the head which made it very simole to get to, I then rebuilt the motor on a stand and found out while installing i can't get to the bolts. Help!!!

 

Don`t know if this will help but I most times remove the transmisson cross member support the trans with a jack lower it down you can then reach the bolts with a couple long extenions use a rachet or air gun hope this helps

 

appreciate it but i got it done like a week and a 1/2 ago, i had it up on a lift, standing under it i used a long extension , universal, and a deep socket with air ratchet