Need Help for my Intake
Thread Starter
Joined: Jul 2004
Posts: 1
From: United States
Need Help for my Intake
I am currently using an AEM intake which was originally was for
a Mits. Galant, but now installed in my Runner. At first I took out
the box which contained the air filter and replaced that w/ a
cone filter. There was a difference in power and better
response. Then I took out the stock tube and replaced that w/
the AEM tube. It feels like it lost power. and when I start up the
engine, usually the needle is about 3 tick makrs above the 1
rpm. Now w/ the AEM tube, the needle starts off at the 4th tick
mark from the bottom.
PLEASE HELP!
thx in advance
a Mits. Galant, but now installed in my Runner. At first I took out
the box which contained the air filter and replaced that w/ a
cone filter. There was a difference in power and better
response. Then I took out the stock tube and replaced that w/
the AEM tube. It feels like it lost power. and when I start up the
engine, usually the needle is about 3 tick makrs above the 1
rpm. Now w/ the AEM tube, the needle starts off at the 4th tick
mark from the bottom.
PLEASE HELP!
thx in advance
Super Moderator
Joined: Oct 2004
Posts: 204
From: United States
Need Help for my Intake
Yours is EFI, I assume? Is your intake sensor hooked up or anything? does the Mits. AEM tube have a spot to hook up the 4Runner's sensor? If I were you, I'd take a look at that... that sensor is pretty important as to how the engine reacts. That's how it knows how much fuel to give to the engine, I believe... Correct me if I'm wrong.</P>
Thread
Thread Starter
Forum
Replies
Last Post